This is a project that I made to take care of an ever increasing need to prototype vacuum tube (valve) circuits. As you can see from the photos, it really is a test "board." I do a lot of work with tubes and love to design and improve circuits. In the process I often use various CAD type programs to rough out the designs. I have frequently found that the models do not agree with the final build. Some are right on, but most are off enough to turn a good idea into a waste of time. Thus the need to quickly prototype designs. Now I could have created this board with many additional features - speakers, output transformers, LEDs... But what I needed was a simple way to test single stage tube circuits. So for simplicity I wired the tube pins together (pin 1 to pin 1 and so on). The leads from the pins are brought out to terminals on a "Euro" style terminal strip. I included several other "Euro" strips, a pair of RCA jacks, a 100 k-ohm variable resistor and solderless prototype breadboard. This solderless breadboard is available in various sizes from several sources. If you build one of these boards, feel free to use the idea to adapt it to your needs and use whatever parts you so desire.